Setek wifi extender help to boost internet signal in the entire home. You can connect it with any router. If you are using Setek wifi extender and facing issues to setting up the extender, so you are making a mistake somewhere. In this article, you will learn about the things that you need to keep in mind while setting up the extender. After read this article you can easily complete the Setek WiFi Extender Setup process. Let’s start:
Be Careful During Installation
There are many things that you need to keep in mind during installation. It is very important to install the extender correctly. Below we are discussing several steps that you must need to follow while installation:
- First of all, connect your extender to the router with Ethernet cable, and make sure your router is turn of while connection.
- Check the Ethernet cable is in good condition which you are use for connection.
- Ensure that your router getting proper power supply.
- The location of the extender should not be too close or too far from the router.
- Make sure your router properly connected to the modem.
- Ensure there is no any damage in the network and power cables.
These steps help you to complete best installation of your Setek WiFi extender at your home. After installation you need to configure the extender to the router via computer.
Unable to Access the Web Interface
After physically install setek wifi extender, next step is login to the setup interface of the extender to configure with router. Many times users facing issues while login to the extender’s web interface. Here we provide some tips to solve this issue:
- Firstly check your computer or laptop device is connected to the network of the extender.
- Use the WiFi name Setek to connect, you will not need to enter password to connect.
- Also use the updated version of web browser to open the extender’s web interface.
- Enter correct IP address 192.168.10.1 into the address bar.
- And also enter the correct username and password to login. (default username is admin and password is password)
- Clear all the cache and cookies of the browser before access the interface.
- Temporary disable firewall and VPN proxy software, they create issues because they are block by the interface.
- Use the different browser, if your existing web browser not able to access the interface.
Follow these steps to solve the issue of unable to login to the web interface of the extender. Just follow all the steps carefully.
If Using the WPS Button
If you are using WPS button to configure the extender to the router, then you do not need to configure the router via the computer. After WPS method, the extender inherits all the settings of the router even password and band settings.
For using WPS method, simply press the WPS button of the router and within two minutes press the WPS button of the extender. It wills takes few seconds or minutes to configure.
Reset
If your sill facing issue with your extender or router to setup, then you need to reset the extender or the route. It restore all the factory default settings of your devices. To reset, simply press the reset button of the device for 5-10 seconds. Extender will going to booting up and takes few minutes to start again.
Conclusion
In the above article, you explore the several tips to settle all the issues that create difficulty to setting up your Setek WiFI extender.